James Smith        October 26, 2020

If the ambient temperature is above -5℃, each engine start can last for 5 seconds, the maximum attempts are three times for cold engine starting up, indicating the engine start is normal. With car technology improved, cold engine starting up is not difficult, but we recommend the cold engine starting up is less than 5 seconds.

James Smith        October 25, 2020

In the daily use of the car, if your auto fault lights illuminate on dashboard, we should dealt with in time, otherwise the car can’t ensure your safety. If there is a fault, it will be display on dashboard. The dashboard can indicate most of the fault, so it is important to know the various fault lights on the dashboard.

James Smith        October 25, 2020

From engine start to parking, a few good habits can keep you from garage. In fact, it is not difficult to cultivate a good car habits, as long as pay a little attention to some details, over time, you will be a good driver. Engine start 1. The ignition The ignition switch of the car is divided into three gears. The first gear is \"ACC\", used to switch on the power, and make the audio, window, and other electric accessories in a working state. The second gear is \"ON\", connecting the electric accessories related to driving, such as ABS, air bag, fuel pump, temperature sensors and so on. The third gear, \"START,\" starts the engine.

James Smith        October 24, 2020

After the vehicle is exposed to the sun, some drivers will give the car a cool shower to make it quickly cool down. But you'll soon find your car is worse than before. Due to exposure to the sun, the temperature of paint and surface coatings and engine are very high, and heat expansion and cold contraction will shorten life of the paint and surface coatings, gradually lose luster.

James Smith        October 24, 2020

When do we maintain our car? What maintenance projects should be carried out. These questions many divers concern, we conclude 6 major maintenance projects. let's go straight. 1. Oil and filter maintenance Oil and filter are projects of the vehicle routine maintenance, These two maintenance are necessary at each routine maintenance, the drivers must replace it in time. There are relatively clear maintenance cycle, if you use full synthetic oil, it need to change after 1 year or 10 thousand kilometers, if you use semi-synthetic oil, we recommend you replace it after half a year or 5 thousand kilometers.

James Smith        October 24, 2020

When the vehicle is stationary, the battery will maintain a slow discharge state, so the vehicle is not used for a long time, should also occasionally start the vehicle to charge the battery (each time to keep idle for 20 minutes). Because the battery is in low power for a long time, its service life will be shortened.

James Smith        October 23, 2020

Symptom When the starter switch is turned on, the starter will make a knocking sound, and the starter can't drive the engine. Failure causes 1. Incorrect adjustment of starter switch or solenoid switch. 2. Improper adjustment of armature movable fixed contacts and movable contact clearance. 3. The pinion or flywheel ring gear wear or slip. 4. Fixed bolts of starter are loose or clutch housing is loose. 5. Internal failure of the starter.

James Smith        October 23, 2020

Battery is not used for a long time, it will slowly self-discharge, until scrapped. Therefore, the car should be started every certain time to charge the battery. Another way is to pull out the two electrodes on the battery. It should be noted the positive and negative electrode cables should be removed from the terminal.

James Smith        October 22, 2020

The car's starter rotates slowly and feebly, which makes it difficult to start the engine. When the starter switch is turned on, the car's starter makes only a \"clicking\" sound and does not start. The reason for slow cranking starter 1. Low battery or loose connection, poor contact. 2. Starter bearing is too tight or loose. The armature shaft is bent, sometimes rubbing against the poles. The brush is too dirty or wear, spring is too weak, armature and magnetic field coil are short circuit. 3. Starter switch contact ablation or coil of solenoid is short circuit. 4. The auxiliary coils of sliding armature starter are disconnected or short-circuit

James Smith        October 22, 2020

A starter motor is an electric motor using gears to turn or start the engine. The working principle of the starter motor can be explained by the working principle of its main component, the DC motor. The DC motor is a device that converts electrical energy into mechanical energy, a charged conductor is subjected to electromagnetic force in a magnetic field. In fact, because the torque produced by a coil is too small and the rotation speed is unstable,actually many coils are wound around the motor's armature, and the number of commutators increases with the number of coils. This ensures a large enough torque and a steady speed.